A structural two-part type modified acrylate adhesive which has excellent adhesiveness on steel, aluminum, stainless steel, FRP and so on. It cures at room temperature to have a good workability. And it has also excellent performances on shock-resistance and peel-off strength to hold a shielding effect. Laborsaving on finishing process, such as stress relief, and cost reducing compare to ordinary welding method can be made with this adhesion method.
用途
配電盤・制御盤・キュービクルの組み立て・金属ドア・パネル等の補強
Application
Assemble of distribution boards, control boards, and cubicles / Reinforcement of metallic doors and panels
1. Surface Preparation ・Rust or dirt should be removed from the adhesive substrate by means of sandpaper, etc. ・Grease on the surface should be wiped off. 2. Bonding Process ・Agent A and agent B should be put on substrate overlaid one to the other with the amount of 1:1 on volume basis. Then, those two agents should be mixed as quickly as possible before substrates are put together. Agents should be placed all over the substrate. ※ The reference amount is approx. 200g/ m2 for rather flat substrate. Fix and hold them still for the curing time, after substrates are put together. ※ If the subject is planed to get some heat treatment, such as baking, adhesive strength may be reduced depending on type of surface treatment for the steel plate. It should be checked first. Especially, it should be carefully to check if the substrate is made of galvanized sheet iron. 3. Since the adhesive is designated as a hazardous material under the Fire Defense Law, please pay attention to fire and air ventilation. In case of fire, please don't apply water but apply the others such as powder or carbonic acid gas extinguisher. 4. Do not mix two agents too much because it would cause an excess heat generation. 5. Safety glasses, gloves, and a mask for organic gases on requirement basis shall be put on. 6. If you feel sick with it odor, go to well-ventilated area and get some rest, and see your doctor if you needed. 7. If you touch the adhesive or if the adhesive get on your clothes, you should wash it out or you may get a rash. In case you get a rash, see your doctor for proper treatment. 8. Should not put it into eyes or mouths. In case of putting it into your eyes, wash your eyes for more than 15 minutes and see a doctor. In case of putting it into your mouth, wash your mouth well and see a doctor. 9. In case of spilling it out, wipe the adhesive off by a piece of cloth or be absorbed by sand, and discard them by entrusting to the industrial waste disposal operator. 10. Keep the agent in a dried, cool and dark storage, avoiding moisture or humidity. 11. Container or the left over shall be treated by the industrial waste disposal operator. 12. Mechanical backing up such as welding or bolt fastening, should be made if there were possibility of causing the personal injury accident by peeling off of the joint. 13. After shipping date on the shipping date label: Approx. 3 months, at 20℃ and less. Approx. 2 months, at 30℃ and less.