技術資料・注意事項トップへ Technical information
Back To Top
MENU

インデント蝶番設計参考凡例 Design Reference for Indent Hinge

(1)割り型組み合わせの数はできれば奇数の方が回転良好です。 Odd number of splint matter combination is recommended for better rotation.

A~Xの数=奇数
Quantity from A-X=Odd number

(2)割り寸法について Knuckle Length

Y寸法はできればY=(L-nx)/2(nはx部の数)の方が外観的にもよい。
Recommended: Y=(L-nx)/ 2(n=Quantity of x)

(3)芯金の太さは Hinge Pin

  • (A) > (B)の場合は巻上がり外観が円型になり難い。
  • 芯金が甚しく材厚に対して大の時は巻がゆるむ恐れがあります。
  • If (A) > (B), the shape of curling will be difficult to be circle.
  • If the diameter of hinge pin is very bigger than panel thickness, the curling will work loose.

(4)巻き上り外径は大略下記の如くなります Roll Dimension as follows

D≒d+(tx2)+d/10 即、芯金の10%程余分に太くなる。
It will be thicken by extra 10% of the Hinge Pin

(5)サラ穴寸法はできるだけサラ径(D)も御指示ください。 Please specify (D) countersink diameter.

  • イ.d=D-t×2(倍)+α
    α:d が計算値より大になる事を示します。即ち、d≧D-t×2
  • ロ.(D-d) < (t×2)の場合及び(イ)に依る自然下穴がご希望より小の場合は下穴径も御明示ください。
  • ハ.サラ角度が90°以外の場合も御明示ください。

  • (1)d≧D-t×2
  • (2)Please specify if the prepare hole is smaller when (D-d)<(t×2)
  • (3)Please specify if the countersunk angle is except for 90°.